|
Post by benjirixon on May 31, 2012 18:21:41 GMT
check out the skills 30 seconds in and the ape at the end
|
|
|
Post by jonnieboz on May 31, 2012 20:47:36 GMT
great.... looks like riding whilst under the effluence that ape looks a good crack - mind ;D
|
|
|
Post by benjirixon on Jun 1, 2012 9:23:06 GMT
Yeah Ape drifting could be a new sport, looked like right good fun !
|
|
|
Post by jonnieboz on Jun 1, 2012 21:14:20 GMT
i guy i know goes to 'golf' most sundays.... has a big breakfast in the clubhouse - then.... spends the whole session ragging the golf buggy round the coarseway - trying to get 'air' out of the bunkers
|
|
|
Post by benjirixon on Jun 2, 2012 8:30:07 GMT
Haha! Awsome that sounds like the sorta golf I'd play. Be even more fun with a rotax engine in the buggy!
Watched that vid of the rotax engine in the 50 spec, ...... Shocking! Apparently the guy got fined for that too as someone reported the vid to the police and with video evidence not much he could say to deniy it really haha!
|
|
|
Post by jonnieboz on Jun 3, 2012 20:54:34 GMT
that would be fun !!! hows that primmy comin' along ben ? ( i was thinking after... i didn't check if the gear gogs were in the right way round - i just put them back as they came off ) i think
|
|
|
Post by benjirixon on Jun 4, 2012 8:07:20 GMT
Yeah it's coming on good. Engine is down Pauls having timing done and I spent the whole day Saturday doing the 12v conversion wiring. Took me best part of 6 hours as I took my time double checking the wiring and making sure all connections were clean and well fixed so nothing to worry about in the back of my mind. Worst part was the bloody light switch, took ages! Oh and making a hole in the inside of the frame for the regulator wires.
As for gearbox I'm sure you done it right. If I go superman style over the bars on the test run I'm guessing its wrong haha ! ;D
|
|
|
Post by pauld on Jun 4, 2012 8:51:31 GMT
if someone else has stripped and rebuilt this motor after i rebuilt it why am I doing the timing?
|
|
|
Post by benjirixon on Jun 4, 2012 11:48:13 GMT
sorry my fault, ....... i put john on the spot a bit really. was just ment to bring just the crank up to be cut, ........ so i stripped the engine down as far as i could but being a newbie couldnt get the flywheel off as didnt have the tool and we checked the gear selector as its jumping outta gear
|
|